Thinkware uses 3M VHB (Very High Bond) double sided tape with industrial strength. This is perfect for fitting a dashcam to a windscreen that endures extreme heat and cold environment’s

Connects to your vehicles fusebox. activates parking mode

Installation of the hardwiring cable to your vehicle’s fuse panel enables the built-in Parking Surveillance Mode in your THINKWARE Dash Cam, while you are away from your vehicle. All Thinkware Dashcams can then monitor your vehicles Battery and will shut down if it detects it getting low. Compatible with all THINKWARE Dash Cam models except for the M1 Mostorsport Cam or F790 Dash Cam

A hardwiring cable allows for custom configuration of your dash cam’s power supply. The hardwiring cable connects the dash cam to the vehicle’s electrical system. The dash cam can be set to stay recording even when the vehicle’s engine is off in the parking mode. The power module will also monitor battery voltage and turn off the dash cam when the voltage gets too low to ensure that the vehicle battery will not go flat.

Full HD 1080P infrared image quality 140 degree viewing angle 0.6M Cable length Dimensions: 61mm (W) x 33mm (D) x 27mm (H)

Increase the duration of the Parking Surveillance mode of your Thinkware Dash Cam with the iVolt Mini External Battery. It allows your Thinkware dash cam to remain in Parking mode for up to 20 hours, or 16 hours with a rear cam added and even longer dependent on the camera and mode used. Compatible with all THINKWARE Dash Cam models. Please note that this requires the Hardwired version of the Dashcam